![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Peter, you saved me the effort of replying further; your replies
stated essentially what I would have said. One comment: The reason I asked for the greatest distance between a GC line and a straight line was that it looked to me, on Kyler's chart, as though it was never more than a few miles. That would indirectly indicate the difference between the distance to destination of the two routes could not be more than a few miles. I can't remember ever planning a flight of more than a couple hundred miles that did not involve dodging around one or more restricted areas or MOAs, so the question about the difference between a straight line and a GC over a long distance is only of academic interest. vince norris |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Landing and T/O distances (Was Cold War ALternate Basing) | Guy Alcala | Military Aviation | 3 | August 13th 04 12:18 PM |
Are sectional paths correct across "long" distances? | vincent p. norris | General Aviation | 32 | March 25th 04 02:32 PM |
"I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 9th 04 11:35 PM |
AVIATIONTOOLBOX: how I convert sectional maps to map chunks | Kyler Laird | General Aviation | 2 | December 4th 03 01:09 AM |