![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I have Charles Taylors biography written by H.R. DuFour which shows the engine
in minute detail. The sparking wires were Platinum. Ignition timing was controlled by a sliding gear on the timing shaft which was in turn, controlled by a small lever mounted on the rear left leg of the engine. Diagonally across from the flywheel corner. Charlie Taylor gets far too little recognition for his part in that epic flight. He designed and built the engine in something like 3 months. Also had a big role in making the propellor. Many people, including DuFour, seem to think Charlie was ill treated by the Wrights but Charlie seemed to have a wild streak in him and often went off on adventures such as volunteering to be the Mechanic for the Vinn Fizz and others. Warren I concur. The "spark points" used on the '03 motor were irridium if I'm not mistaken. And the "magneto" was friction drive off of the flywheel. You may find more info. by doing a Google search on Charlie Taylor, who was the Wrights' engine specialist and a master machinist. You might also try contacting Nick Engler at Wright Brothers Airplane Company. He'll build you a replica engine if you've got tons of cash to burn. If that doesn't do it, you might try contacting The Wright Experience, which is the official EAA / Ford Motor Company sponsored team. Fortunately, my Wright ship is motor free! Harry |
#2
|
|||
|
|||
![]()
Unfortunately, Charlie's reported fondness for doing the kind of things
machinists like to do (drinkin' smokin', 'n swearin') didn't sit too well with Katharine... or so I've read. The friction may have been the original source of the lack or recognition. Now here's a better subject: Where in HELL do you suppose the Wrights came across platinum wire and irridium spark points? Most of the materials used in the airframe were fairly easy to source in 1900 - 1903, but these must have been pretty tough. Also, how do you suppose Charlie got the crankshaft to ballance so well considering the methods he used to fabricate it? My respect for these men continues to grow. They were infinately more skilled than I am. Harry Wright 1902 glider #8 |
Thread Tools | |
Display Modes | |
|
|