![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() "Maule Driver" wrote in message . com... NC by any chance? Yep. Harnett Co. airport in Erwin. -Trent |
#2
|
|||
|
|||
![]()
Figgers. There's a lot of that strange stuff going on in NC...Unmarked G4s
zooming out of unmarked hangars. "What was that?" "What? That?" "Don't know...". "You've been here 10 years, what do you mean you don't know!" "Trent Moorehead" wrote in message ... "Maule Driver" wrote in message . com... NC by any chance? Yep. Harnett Co. airport in Erwin. -Trent |
#3
|
|||
|
|||
![]()
Maule Driver wrote:
Figgers. There's a lot of that strange stuff going on in NC...Unmarked G4s zooming out of unmarked hangars. "What was that?" "What? That?" "Don't know...". "You've been here 10 years, what do you mean you don't know!" Yep, like the 747 and the IL-62 that were used last year at Laurinburg-Maxton NC (MXE) by someone for what appears to be HRT training. they are gone now, cutup for scrap, but we found lots of 9mm paintball rounds, casings and silhouette targets on board, just before they were scrapped. Just for reference... http://home.earthlink.net/~silverrequiem2/maxton.htm |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
"bush flying" in the suburbs? | [email protected] | Home Built | 85 | December 28th 04 11:04 PM |
Landing patterns | m pautz | Piloting | 31 | June 18th 04 03:29 PM |
Study pilot workload during approach and landing | Freshfighter | Piloting | 5 | December 7th 03 04:06 PM |
Logging x/c time and definition of landing | Koopas Ly | Piloting | 20 | November 25th 03 08:41 PM |
Help - I busted into the Class B SEATAC airspace last night, does anyone have any advice ? | steve mew | Piloting | 38 | October 28th 03 06:08 PM |