![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
![]()
"Dale" wrote in message
... If you didn't either climb above and dive down or === leave the power up to accelerate to cruise speed === it would make about a 10-15 mph difference in speed. [emphasis mine] True...that's what's already been said. Though, in truth, if you you simply set cruise power, you would eventually accelerate to the desired cruise speed. It would just take a lot longer. The method we prefered and used was to climb above the desired altitude and dive back down. This was quicker than using power to accelerate. No, it wasn't. Basic thermodynamics (conservation of energy) dispute that claim. The time you spent climbing could have been spend accelerating at climb power, and in the end you'd reach your cruise speed at practically the same time either way. A pilot that was ham fisted in pitch could bleed off the speed at cruise and end up on the low end. He'd have to be pretty ham fisted to drop from cruise speed all the way down below best L/D to the other equilibrium speed for the power setting. A pilot that ham-fisted shouldn't be trusted with a Cessna 150, never mind a B-24. Pete |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ultralight Club Bylaws - Warning Long Post | MrHabilis | Home Built | 0 | June 11th 04 05:07 PM |
Flying is Life - The Rest is Just Details | Michael | Piloting | 55 | February 7th 04 03:17 PM |
Announcing THE book on airshow flying | Dudley Henriques | Piloting | 11 | January 9th 04 07:33 PM |
Announcing THE book on airshow flying! | Dudley Henriques | Military Aviation | 2 | January 7th 04 03:41 PM |
U.S. NAVY TO TEST FLYING SAUCER | Larry Dighera | Piloting | 0 | December 22nd 03 07:36 PM |