![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
AES/newspost wrote:
In article , Ron Garret wrote: It depends on the reason for the go-around. Some go-arounds are because controllers get the spacing too tight as we come down the pipeline. Some go-arounds are because the plane in front of us didn't expedite off the runway as the controller requested. Some go-arounds are because an inattentive pilot or truck driver committed a runway incursion in front of a landing plane. Even for those go-arounds were the pilot is at blame, a go-around displays better judgement than continuing a landing and making a bad situation worse. I was a passenger some years ago on a United something coming up the Bay into SFO, probably 28L or 28R, that did a go-around for one of these reasons. I realized what was happening, but was still slightly white-knuckled over how long it seemed to take for the engines to get spooled back up and the aircraft to stop descending, level off, and start climbing out. Not at all like the feeling of climbing up off the runway following rotation on takeoff. I don't understand the issue. A "go around" is a standard proceedure which as a pilot, I have executed a number of times. If things aren't "right", you go around. I have been on several commercial flights (major airlines) where the pilot has made the same decision. The major problem there is the wasted fuel and lowered profits. When in doubt, go 'round. |
Thread Tools | |
Display Modes | |
|
|