![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
"Justin H" wrote in message ...
My Lycoming o-290 swallowed an exhaust valve and i suspect metal in the oil cooler. where is a place that does experimental work that could check it. thanks in advance for anybodys help Damage like that and ANY indication of the possiblity of having metal in the engine and I would do a complete teardown and inspection. A teardown and inspection now is a heck of a lot cheaper than having a catastrophic failure sometime in the future. There is nowhere that I have to be or have my family at, that would cause me to put them onboard the aircraft without having done a complete inspection after an incident that might have put abnormal amounts of metal in the oil system. YMMV...but when it comes to my family, I am much more cautious than normal. Craig C. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 10:18 PM |
Deburring sheet metal and filing edges? | DL152279546231 | Home Built | 1 | April 25th 04 12:47 AM |
Oil cooler? | Rick | Home Built | 1 | March 22nd 04 09:41 AM |
Oil Cooler for Auto-Conversions | Bruce A. Frank | Home Built | 0 | October 30th 03 06:06 AM |
Sheet metal shear/press brake | VideoFlyer | Home Built | 7 | October 7th 03 07:08 PM |