|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
January 8th 05, 03:30 AM
|
|||
|
|||
http://www.allstar.fiu.edu/aero/airflylvl3.htm
Sam White wrote: I am Mech Eng student at Imperial College in London and I have to give a presentation on wing design and airflow control surfaces. If anyone has any ideas on sites where I may be able obtain such information, doesn't need to be to advanced. 
|
|
#2
January 8th 05, 09:55 AM
|
|||
|
|||
|
Fabulous link, mate. This, JSD's and a couple more and the ones here
who want me gone will have their wish  Ramapriya john smith wrote: http://www.allstar.fiu.edu/aero/airflylvl3.htm
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| amateur design consultant? | Shin Gou | Home Built | 14 | June 30th 04 01:34 AM |
| Design merit of blended wing aircraft | Rob Mohr | General Aviation | 0 | June 13th 04 02:45 PM |
| Flying Wing Design workshop in july 04 | mat Redsell | Home Built | 1 | May 5th 04 01:53 PM |
| Flying Wing Design workshop | mat Redsell | Home Built | 2 | March 31st 04 05:27 PM |
| Props and Wing Warping... was soaring vs. flaping | Wright1902Glider | Home Built | 0 | September 29th 03 03:40 PM |
Hybrid Mode
