A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Rotorcraft
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Seating Arrangements



 
 
Thread Tools Display Modes
  #1  
Old April 23rd 04, 01:33 AM
Stu & Kathy Fields
external usenet poster
 
Posts: n/a
Default

In a little sky-earth-helicopter situation in which I started as pilot and
ended as passenger, the trans was pulled out of the frame taking a bunch of
bolts with it (didn't bust the aluminum casting!! I'm still amazed) and the
blades, tho not in a condition useful for anything but a "Don't do this at
Home" display were still intact.

Stu Fields Safari builder X2
wrote in message
...
I was told by the factory IP's to put it in to the right (pilot side)

after
the auto. This would cause the transmission to rip off
aft rather than coming forward into the cockpit.


You would think that the blades or drive would fail before the trasmission
mounts.

Pilot on on the left is better for lift work, better collective control

when
looking out the window.



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Embraer seating marc General Aviation 13 January 28th 04 02:08 AM
1/2 place flex seating configuration Jay Home Built 12 December 19th 03 05:40 PM
A/C Retrofit for Cherokee Six John Pelchat Owning 8 December 3rd 03 12:57 AM
Pictures Showing WWII Rotary Engine Crankshaft Arrangements: Where, Please ? Bob Military Aviation 8 November 8th 03 06:08 PM


All times are GMT +1. The time now is 04:14 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.