|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 30th 03, 02:10 PM
|
|||
|
|||
"Dave Martin" wrote in message ... Various methods such as hot wire and laser beams have been suggested, but with the way members treat club equipment I suspect the life of such things would be minimal. Dave Martin Why should a hot blade be fragile? The winch engine starting battery has a lot of power to heat a robust blade very quickly. You only need to get the blade to Spectra's 265F melting point - far below the blades melting point. I would just mount the blade in a strong frame near the path of the rope and push the rope against the stationary hot blade with a rubber block. If well built, it should last nearly forever. Bill Daniels 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plasma Reduces Jet Noise (Turbines?) | sanman | Home Built | 1 | June 27th 04 12:45 AM |
| Plasma Reduces Jet Noise (Turbines?) | sanman | Rotorcraft | 1 | June 27th 04 12:45 AM |
| Using Plasma Rope For Winch Tows | Craig Freeman | Soaring | 56 | August 24th 03 10:55 PM |
| Winching: Steel vs. Plasma | Bob Johnson | Soaring | 10 | August 12th 03 05:41 PM |
| 2nd update on Review of Plasma II Ignition System | MikeremlaP | Home Built | 8 | July 22nd 03 01:37 AM |
Hybrid Mode
