|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 28th 03, 09:31 AM
|
|||
|
|||
I think that Miguel was asking the difference between gel coat and
poliurethane paint. Anyway I don't have enough knowledge about the matter to explain it! "BTIZ" escribió en el mensaje news:4ljnb.94824$La.83537@fed1read02... as long as the surface below was properly prepared.. should be ok.. that is the standard for replacing old gel coats.. sand it down.. re profile the wing.. and paint it.. BT "Miguel Lavalle" wrote in message ... I am considering buying a second hand glider that was recently = refinished with poly paint as opposed to gel coat. What is poly paint? What are the pros and cons of poly paint compared to gel coat? Regards Miguel 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Paint Stripper? | PETER H. OUELLETTE | Home Built | 9 | November 30th 04 06:12 PM |
| One coat paint for aluminum? | [email protected] | Home Built | 10 | September 17th 04 07:01 AM |
| Good Paint Remover? | Marco Leon | Owning | 2 | June 22nd 04 07:58 PM |
| Radar Absorbing Paint | robert arndt | Military Aviation | 2 | December 2nd 03 05:09 PM |
| Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 02:51 AM |
Hybrid Mode
