|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 11th 04, 10:38 PM
|
|||
|
|||
I have a Cleveland parking brake line lock on my Dragonfly. The part number
is 60-5. It has developed a leak, the fluid is coming out of the body where the actuator arm connects. You need three MS28775-010 orings for the shaft. There are two other orings for fittings and poppet valves. Those are MS28775-006 and -012. The poppet valves might fall down into the shaft cavity when the shaft is removed. John Dupre' 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Goodyear Brake Pucks - Cheap! | Ron Wanttaja | Home Built | 7 | July 16th 04 06:45 AM |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 06:15 PM |
| FS: Aircraft Instruments Parts Avionics Warbird Parts | Bill Berle | Home Built | 0 | January 10th 04 02:20 AM |
| Brake caliper flange | Stealth Pilot | Home Built | 5 | July 7th 03 04:19 PM |
| Brake line design question | Charlie Smith | Home Built | 0 | July 2nd 03 12:31 PM |
Hybrid Mode
