![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Mark James Boyd wrote:
Well, some of the power accidents are just newer pilots that weren't trained to properly react to the horn. In some I suspect the horn wasn't even working (I've been surprised by failed horn a few times). The airspeed idea is good (better than nothing) but doesn't tell the AOA at both wingtips, This probably won't be useful for landing, since the selected airspeed should be high enough to make the AOA at the tips irrelevant. and doesn't seem to account for the G loading in a tight turn. Take another look: both the DSI and the 302 have accelerometers that let them account for G loading. Anyway, the stall/spins typically aren't from tight turns, but shallow ones. Also, as another poster pointed out, the horn detects gusts, which is pretty useful IMHO. I think any gusts that affect your landing will be readily apparent as the glider twitches and bobs in response to them. Certainly they are noted by the pilot while thermalling. Maybe it's time to give airspeed alerts in the pattern a chance. -- ----- change "netto" to "net" to email me directly Eric Greenwell Washington State USA |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
For Auction: Thermal Imaging Camera - One Day Left | sell2all | Rotorcraft | 0 | April 29th 04 08:29 PM |
For Auction: Thermal Imaging Camera - One Day Left | sell2all | Naval Aviation | 0 | April 29th 04 08:09 PM |
For Auction: Thermal Imaging Camera - One Day Left | sell2all | General Aviation | 0 | April 29th 04 08:09 PM |
Spin on thermal entry - how-to | Bill Daniels | Soaring | 0 | January 29th 04 05:43 PM |
Thermal to Wave contact! | C.Fleming | Soaring | 1 | January 21st 04 01:54 PM |