|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 5th 04, 09:03 PM
|
|||
|
|||
Is it ok to reuse mylars after proper cleaning? Yes, remove them without bending (creasing) a hair dryer may help, then remove all the stickie stuff with acetone. get them perfectly clean? With acetone. Sand 10mm strip, inside area with 220, do same on wing area where mylar goes, then wipe everything down with acetone. I use a small roller to apply considerable force on the mylar to insure good bonding to the stickie stuff. Put on your transition tape and then wax. JJ Sinclair 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mylar seals wing to flap/ Aileron | culverflyer | Soaring | 2 | May 5th 04 02:52 PM |
| ZZ Mylar seals | Mike | Soaring | 3 | March 29th 04 03:45 PM |
| mylar seals | D.A.L | Soaring | 1 | February 23rd 04 07:15 PM |
| Mylar tape wing seals - effect on wing performance | Simon Waddell | Soaring | 8 | January 1st 04 03:46 PM |
| Mylar (again) | JJ Sinclair | Soaring | 0 | December 11th 03 10:40 PM |
Hybrid Mode
