![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
On Wed, 10 Nov 2004 00:14:24 +0200, "ahlbebuck" wrote:
Hello, Ron! You wrote on Sat, 30 Oct 2004 19:27:48 GMT: ?? Neat. And good resolution for a $125 camera too: RW And the camera price has come down, too... less than $100 at Target. is that a crack in the landing gear? - just above the left bolt The crack is actually the location of a non-structural butt joint. The gear itself is laminated from 1/4" spruce, with alternate planks overlapping. The narrow end of alternate pieces butts up against the narrow edge of another. The glue area is so small that the glue tends to crack over time. Again, the join isn't structural in nature...the gear laminations are held together by the overlapping areas and pinned by the bolts holding the axle plates. Ron Wanttaja |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tail flapper failure | Veeduber | Home Built | 2 | May 22nd 04 06:52 AM |
twin tail questions | Kevin Horton | Home Built | 12 | January 2nd 04 03:21 PM |
tail buffeting and leading edge fillets, strakes | Wallace Berry | Home Built | 1 | September 26th 03 10:48 PM |
Oshkosh Get together Roster - Sign in, please! | Bruce E. Butts | Home Built | 4 | July 26th 03 11:34 AM |