|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 29th 04, 05:36 PM
|
|||
|
|||
Better to use rotatating guides on bearings at the entrance and exit holes.
Plastic would burn through in no time at all. The Spectra could be protected from the edges with a cut-able, thin wall plastic tube inserted into the through-hole. Jim Vincent N483SZ illspam 
|
|
#2
October 29th 04, 06:14 PM
|
|||
|
|||
|
I didn't mean to use the guillotine in place guide rollers. With the
Spectra under tension, guide rollers should prevent it from touching the guillotine. However, a thin plastic tube would keep dirt and moisture out of the guillotine block so it wouldn't rust or jam. It would also prevent the Spectra from touching the steel edges when not under tension. Bill Daniels "Jim Vincent" wrote in message ... Better to use rotatating guides on bearings at the entrance and exit holes. Plastic would burn through in no time at all. The Spectra could be protected from the edges with a cut-able, thin wall plastic tube inserted into the through-hole. Jim Vincent N483SZ illspam
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Smart CDI diesel engine | Hans Zwakenberg | Home Built | 14 | January 9th 05 12:32 PM |
| Aerotow with Diesel engine? | Olfert Cleveringa | Soaring | 44 | November 2nd 04 10:22 AM |
| Engines and Reliability | Dylan Smith | Piloting | 13 | June 30th 04 03:27 PM |
| Diesel engine | Bryan | Home Built | 41 | May 1st 04 07:23 PM |
| Emergency Procedures | RD | Piloting | 13 | April 11th 04 08:25 PM |
Hybrid Mode
