|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
February 17th 05, 04:45 PM
|
|||
|
|||
George Patterson wrote:
Wear a dust mask. They took talc out of sheet rock compound because of health concerns over people breathing the dust. They still put talc in drywall. What they are careful now about is making sure it's not contaminated with asbestos (much mined talc contains it). NIOSH recommends a mask anyhow. Just about any of the silicate's dust is bad to breath in quantity. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 1 | January 2nd 04 09:02 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 2nd 03 03:07 AM |
| Ford V-6 engine work | Corky Scott | Home Built | 19 | August 21st 03 12:04 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 05:12 AM |
| Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 04:50 PM |
Hybrid Mode
