|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 23rd 04, 01:24 AM
|
|||
|
|||
wrote in message ... On Wed, 22 Dec 2004 16:25:23 -0800, Ed Sullivan wrote: snip I remember someone talking about a damper that was filled with steel shot or similar, but I cannot find a reference to it now. I can't recall the name, but they were used by Molt Taylor in his pusher designs and were also used with the Honda Civic engine in some BD-5s Ed Sullivan They were made by Dodge Power products, and I think they were called FlexiDyne? BINGO--- http://www.dodge-pt.com/products/pt_...flexidyne.html 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "bush flying" in the suburbs? | [email protected] | Home Built | 85 | December 28th 04 11:04 PM |
| Cessna Steel Landing Gears, J-3 Seat Sling For Auction | Bill Berle | Home Built | 0 | February 19th 04 06:51 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
| Off topic - Landing of a B-17 | Ghost | Home Built | 2 | October 28th 03 04:35 PM |
Hybrid Mode
