|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 2nd 05, 12:55 AM
|
|||
|
|||
If connectme is running in the background, then Seeyou
won't be able to use the serial port, quit connectme. Todd 
|
|
#2
March 2nd 05, 01:54 AM
|
|||
|
|||
|
I quit connectme which stoped the beeping and now the lcd gives the gps
status of 3d and 6 satalites. SeeYou mobile still says "no Gps Data" any other suggestions. Thanks Devin Bargainnier
|
|
#3
March 2nd 05, 02:03 AM
|
|||
|
|||
|
Do a soft reset of the ipaq. Push in the small hole on the bottom of
the iPaq with the stylus. This should reset everything. If you use both pieces of software, you need to make sure you exit one before you use the other. Kevin Christner
|
|
#4
March 2nd 05, 02:27 AM
|
|||
|
|||
|
Good idea but still no GPS data
Devin Bargainnier
|
|
#5
March 2nd 05, 03:34 AM
|
|||
|
|||
|
In the colibri setup menu, there is a section about NMEA data. Check
this section to assure that there are several strings with a "Y" next to them. If not, enable the the first three options by moving the N to the Y. Kevin
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Colibri problem | Ian Cant | Soaring | 1 | August 19th 04 07:30 AM |
| iPaq wiring, cradles and mounts for gliders - Ideas?? | Jim Kelly | Soaring | 12 | December 4th 03 11:45 PM |
| RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 09:10 PM |
| RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Owning | 77 | December 3rd 03 09:10 PM |
| iPaq screen viewability | Raphael Warshaw | Soaring | 7 | July 27th 03 06:02 PM |
Hybrid Mode
