|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 30th 04, 03:57 PM
|
|||
|
|||
Well yea, but that's what I thought Brian had a problem with, i.e., not
how many rivets are in the aircraft, but how many he personally had to set. With the QB kit, the number of rivets the builder has to set is inconsequential. MJC "Matt Whiting" wrote in message ... MJC wrote: ... or it that's a "problem" for you, do what I did. RV7-A Quickbuild kit. Poof; lot's less rivets :-) I thought the design was the same and hence the same number of rivets ... just fewer for you to set! :-) Matt 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "C-175 SoCal Beware" Original Poster Replies | Bill Berle | Home Built | 3 | July 8th 04 07:01 AM |
| Poppers Revisted and the Return of the Teenie Two | Veeduber | Home Built | 0 | March 29th 04 09:57 AM |
| Patching Baffling, 3/32 C-Sunk Rivets, 1100 Aluminum? | jls | Home Built | 3 | February 3rd 04 12:15 AM |
| Bonded aluminum aircraft structures | asennad | Home Built | 9 | December 31st 03 02:58 PM |
| Dimpling and riveting pressures | Max Krippler | Home Built | 5 | November 11th 03 08:03 PM |
Hybrid Mode
