|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
January 7th 05, 03:28 PM
|
|||
|
|||
If you install the fittings so the female one points up you could fill
it with oil before connecting then join them without getting any air into the system. My question is why do you need this. How would you disconnect pressurized line? If you can deal with a little bit of air, there are a number of options. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Straight restrictor fitting? | nauga | Home Built | 5 | April 15th 04 01:06 PM |
| Hydraulic CS prop converting to Adjustable prop? | Scott VanderVeen | Home Built | 0 | December 5th 03 05:54 PM |
Hybrid Mode
