![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Jim,
If I were welding it, it wouldn't be welded!!! HAHA It would be riveted and sloshed. However the fellow that will be doing the welding welds at nuclear facilities and has an xray certification. I know his work very well, and it won't leak. Patrick student SPL aircraft structural mech "Morgans" wrote in message ... "W P Dixon" wrote . For the gas tank, it will be in a VP-1. I am welding aluminum instead of using the fiberglass. An old high school buddy, certified nuclear welder is going to weld it up for me. Why not make it round on the ends, and just wrap it, instead of having flat sides? Less welds to leak. That is, if you are welding each flat to the other. If you are going continuous, nevermind! g -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Good morning or good evening depending upon your location. I want to ask you the most important question of your life. Your joy or sorrow for all eternity depends upon your answer. The question is: Are you saved? It is not a question of how good | Excelsior | Home Built | 0 | April 22nd 05 01:11 AM |
VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
Legal question - Pilot liability and possible involvement with a crime | John | Piloting | 5 | November 20th 03 09:40 PM |
Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
Special Flight Setup Question (COF) | Dudley Henriques | Simulators | 4 | October 11th 03 12:14 AM |