|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 17th 05, 07:43 AM
|
|||
|
|||
"Bruce" wrote in message news  wrote: A two inch ball equals 50.8 mm. I would think that would be close enough for most applications. Two inch balls are a lot cheaper. Clay Thomas That it would . . . but it's a little tough getting that new 50 mm receiver hitch to fit down on that ever-so-slightly too big 2" ball. Newer Cobra trailers can be ordered with 2" hitches for the US market. bumper 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ball vario overhaul? | Anthony Turiano | Soaring | 6 | June 17th 09 08:06 PM |
| wanted L'Hotellier ball fitting assembly | Udo Rumpf | Soaring | 3 | January 7th 05 03:05 AM |
| Eye Ball Vent | B. Iten | Soaring | 4 | September 4th 04 09:38 AM |
| Ball 100 Vario Repair? | Bob Johnson | Soaring | 0 | August 19th 04 03:27 PM |
| Trailer hitch inadvertant disconnect | Bill Daniels | Soaring | 5 | July 16th 04 03:17 AM |
Hybrid Mode
