![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Morgans wrote:
"Lakeview Bill" wrote in message . .. Just out of curiosity, why do you dislike the Rotax? How shall I count the ways? They require their oil, their oil filters, their everything. You pay dearly for this. They always have seemed to be temperamental. Everything has to be just right, to be even close to reliable. See above. If everything is not just right, they are not reliable. I know the 912 and 914's are not 2 strokes, but what pieces the 2 strokes are. I know, some will testify that they have never had a minute's problem, but there are more out there that have. My gut, and my but says to not trust them. I don't and I won't. Gut means a llot, to me. I have to disagree with your assessment of the Rotax 2-strokes here, it's just not informed. I've owned 6 of them over the years (just now got #7 delivered a few weeks ago), 5 503's and a 2 447's. I have hundreds of hours in front of/underneath Rotax 2-strokes at this point (500 hours as a rough guess) so I've gotten to know some of their strengths and weaknesses. The chief strength of the Rotax 2-strokes is the field experience available. We know how to install them, prop them, jet them, load them, maintain them and what parts and peripherals to use with them. This is the _#1_ strength of the Rotax - it's not so much that it's such a superior design (it's not much more than a snomobile engine with a beefed up bottom end and slightly different metallurgy in certain places like the pistons), but again it's field experience we have available for setup, installation and running that really makes them reliable. They are also the only 2-stroke on the market that can really do continuous high power for hundreds and hundreds of hours without failure (provided it's installed, setup and run right, of course). The chief weakness is probably the same as for all 2-strokes; they can't handle a lot of abuse such as lean running, underpropping and so on. They also require more frequent maintenance (typically for leaking seals). But the truth is, the rotax 2-strokes are very reliable, long lasting engines. I know a lot less about the 912, since I've never owned one, so can't comment on those (I don't know of any rampant reliability problems with them, though, from the fairly numerous locals who fly them). They don't sound "manly" enough. Kinda like a sewing machine, compared to a Harley. Airplanes are supposed to be "cool", and they aren't. :-) I kind of like the scream of a 2-stroke rotax, but that might just be because I'm used to it. OTOH, the coolest sounding is the merlin in the P51..... LS N646F |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Light Sport Aircraft for Private Pilots (Long) | Jimbob | Owning | 17 | March 1st 05 03:01 AM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 1st 04 02:31 PM |
Homebuilt Aircraft Frequently Asked Questions List (FAQ) | Ron Wanttaja | Home Built | 0 | September 2nd 04 05:15 AM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 05:12 AM |
Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 04:50 PM |