![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() I have often wondered about inertia and twins in general: with the engines off the centerline was it harder to get a twin into a roll, and harder to stop? -- Saville Replicas of 15th-19th century nautical navigational instruments: http://home.comcast.net/~saville/backstaffhome.html Restoration of my 82 year old Herreshoff S-Boat sailboat: http://home.comcast.net/~saville/SBOATrestore.htm Steambending FAQ with photos: http://home.comcast.net/~saville/Steambend.htm |
#2
|
|||
|
|||
![]() "gregg" wrote in message ... I have often wondered about inertia and twins in general: with the engines off the centerline was it harder to get a twin into a roll, and harder to stop? Saying nothing of P effects, and torque, it is the fact that a object with most of it's weight at the center is easier to spin. Think of the figure skater pulling the arms in. She started with arms out, slowly. Arms in, the same energy spun her faster. -- Jim in NC |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
It's finally running! | Corky Scott | Home Built | 19 | April 29th 05 04:53 PM |
Finally got my X-country in.. | PJ Hunt | Rotorcraft | 0 | December 18th 04 10:50 AM |
Cobra Tongue Strut Removed Finally | Brian Iten | Soaring | 0 | December 4th 04 07:54 PM |
Finally flying new Skyhawks! | Scott Schluer | Piloting | 11 | February 24th 04 10:02 PM |
It’s finally ready! | Joern Lillehagen | Home Built | 0 | September 4th 03 02:11 AM |