A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Piloting
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Jim's EAA Platform '05



 
 
Thread Tools Display Modes
  #1  
Old July 10th 05, 08:55 PM
RST Engineering
external usenet poster
 
Posts: n/a
Default

My first read on this when you said it was a coop was that you converted an
old chicken coop for a school. Cooperative. Got it the third time through
{;-)

I hope I've PULLED you over the edge. I found out a long time ago it is a
hell of a lot easier to get a rope to move by getting out in front and
pulling than pushing from the other end {;-)

Congrats on making the aviation thing happen in your classroom.

Jim



My son is starting, at the pre-k level, in a pre-k through 7 (with 8 to be
added shortly) this year. It's a coop, which means that parents are
involved at various levels.

I'm going to see what I can steal from your ideas for use w/in the school.

More, I think you've finally pushed this AOPA member over the edge of also
joining the EAA. I've always been a little put out by the E part, even
though I know plenty of EAA members that fly FAA certified. But you've
reminded me of the emphasis on education the EAA places, and that's
enough.



  #2  
Old July 10th 05, 10:27 PM
Andrew Gideon
external usenet poster
 
Posts: n/a
Default

RST Engineering wrote:

My first read on this when you said it was a coop was that you converted
an
old chicken coop for a school. Cooperative. Got it the third time
through
{;-)


I'm not sure that there's *that* much of a distinction, but yes.

laugh

I hope I've PULLED you over the edge. I found out a long time ago it is a
hell of a lot easier to get a rope to move by getting out in front and
pulling than pushing from the other end {;-)


You mean "pull" like the rudder or elevator? I was thinking "push" like the
flaps.


Congrats on making the aviation thing happen in your classroom.


That's premature. You should be wishing me luck...and providing any
suggestions you might have as to how this should be done. Materials I can
either give to teachers or use to develop a little mini program I can embed
would be quite welcome.

I'm starting from scratch. For example, what about a contest for the
construction of paper airplanes? Winners (multiple metrics including
longest duration and greatest distance) get a flight. Would parents go
along (in either sense of the word {8^)?

If not, perhaps I can convince a local aviation museum, at which a friend
works, to donate some time on their F-something simulator.

I do have a fair collection of "age appropriate" books on aviation for my
son. I expect that this will continue. One of my favorites at the moment
is "I love planes". It gets one little detail *very* right: the boy
"speaking" in the story is at a ball game with his family. The audience in
few on that page is watching the game...all except the boy and his Mom (the
pilot in the family) who are looking at a nearby blimp.

- Andrew

  #3  
Old July 11th 05, 02:52 AM
RST Engineering
external usenet poster
 
Posts: n/a
Default

I did that contest at Oshkosh about twenty years ago. A very brilliant
aeronautical engineer (who is the owner of Aero-Trim, Norm Smith) got the
award for best distance for wadding up the paper into a spitball and
launching it at a 45d for best distance and taking the same spitball and
launching it at near 90d for best time. Try it. Spitballs at low mach are
very efficient.

{;-)

Jim



I'm starting from scratch. For example, what about a contest for the
construction of paper airplanes? Winners (multiple metrics including
longest duration and greatest distance) get a flight. Would parents go
along (in either sense of the word {8^)?



  #4  
Old July 12th 05, 09:38 PM
Andrew Gideon
external usenet poster
 
Posts: n/a
Default

RST Engineering wrote:

TryÂ*it.Â*Â*SpitballsÂ*atÂ*lowÂ*machÂ*are
very efficient.


Why not just wrap the paper around a rock? In a Fed Ex envelope.

I'm stuck. On one hand, I'd want to see that sort of thing prohibited from
a contest. On the other hand, one should certainly be rewarded for
thinking outside the box.

Laugh

- Andrew

  #5  
Old July 12th 05, 10:17 PM
RST Engineering
external usenet poster
 
Posts: n/a
Default

Because the rules read: One piece of 20# bond typewriter/copier paper 8½ x
11" plus two pieces of "magic mending" tape not more than 1" wide and a
total of 2" long. That's all. No paperclips, rocks, or other materials.

Jim



Why not just wrap the paper around a rock? In a Fed Ex envelope.

I'm stuck. On one hand, I'd want to see that sort of thing prohibited
from
a contest. On the other hand, one should certainly be rewarded for
thinking outside the box.



  #6  
Old July 13th 05, 10:40 PM
Andrew Gideon
external usenet poster
 
Posts: n/a
Default

RST Engineering wrote:

NoÂ*paperclips,Â*rocks,Â*orÂ*otherÂ*materials.


Hey! It would appear that saliva is precluded.

- Andrew


  #7  
Old July 12th 05, 10:52 PM
external usenet poster
 
Posts: n/a
Default


Andrew Gideon wrote:
RST Engineering wrote:

Try it. Spitballs at low mach are
very efficient.


Why not just wrap the paper around a rock? In a Fed Ex envelope.

I'm stuck. On one hand, I'd want to see that sort of thing prohibited from
a contest. On the other hand, one should certainly be rewarded for
thinking outside the box.


Back in my high school physics class, we had a project where we had to
build something to hold one egg, which would be dropped out a 3rd-floor
window, and survive, with a budget of I think 99 cents. Everybody else
build these contraptions with strings and rubber bands, or parachutes
that were too small. I took a packet of gelatin, a Big Gulp cup from
7-11, and molded the egg in the middle. 39 cents. Made one hell of a
SPLAT when it landed but the egg didn't break. Cheapest one that
worked, so I got the prize.

-cwk.

  #8  
Old July 13th 05, 12:06 AM
Montblack
external usenet poster
 
Posts: n/a
Default

)
[snip]
Back in my high school physics class, we had a project where we had to
build something to hold one egg, which would be dropped out a 3rd-floor
window, and survive, with a budget of I think 99 cents. Everybody else
build these contraptions with strings and rubber bands, or parachutes
that were too small. I took a packet of gelatin, a Big Gulp cup from
7-11, and molded the egg in the middle. 39 cents. Made one hell of a
SPLAT when it landed but the egg didn't break. Cheapest one that
worked, so I got the prize.



Mine was similar: an empty medium size oatmeal container, a quart baggie
full of applesauce (with pressure release holes punched in it), a rock in
the bottom to right-side-up the container, some Wheaties as packing peanuts,
and my egg - cocooned in the applesauce bag. Guy on the school roof
"flipped" my oatmeal tube. That little egg didn't stand a chance hitting
upside-down.


Montblack

  #9  
Old July 11th 05, 07:20 AM
Morgans
external usenet poster
 
Posts: n/a
Default


"Andrew Gideon" wrote

You mean "pull" like the rudder or elevator? I was thinking "push" like

the
flaps.


I was thinking "pushed", as in *out* the open door of an airplane, without a
'chute! g
--
Jim in NC

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Jim's EAA Platform '05 RST Engineering Home Built 18 July 14th 05 09:57 PM
Hydraulic Motion Platform saotware and hardware [email protected] Simulators 3 November 13th 04 01:28 AM
Flying Platform Ballchain Home Built 1 October 7th 04 10:17 PM
flying platform Bill3 Home Built 5 October 5th 04 07:00 PM
172P vs 172R for instrument platform..... Jonathan Instrument Flight Rules 6 July 22nd 04 01:52 AM


All times are GMT +1. The time now is 02:01 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.