Last Call - Any Yoke changers out there?

Geronimo, as far as I know, is a pretty good outfit. I've talked to them on
the phone a couple times regarding heater upgrades. They've had that note
about the Coming-Soon Ram's horns on their site for quite a while though, so
I'm not holding my breath.

Jim


"nobody" wrote in message
t...
Hi Jim,

You nailed it. I do wonder how many are sold.

I found another future source of this, according to
their web site:
http://www.geronimomontana.com/apache.htm

Down a the bottom of the page, they mention 3 items
of interest in the coming-soon category: Ram's-horn
yokes at $1295 per pair, new engine and fuel gauges
(this sound very interesting), and dual brakes.

As a PA-23 owner, you might want to check this site out
if you've not already seen it.

Ronnie


"Jim Burns" wrote in message
...
Hey Ronnie,
I just looked at Avion's site and it looks like it would only cost us
$1200
to do the Aztec! Makes you really wonder if they sell any doesn't it?
Jim

"nobody" wrote in message
.. .
Mike,

I was really hoping you'd get an answer to this. I have
a 1964 Piper Aztec that I'd like to do the same thing
with, but when I looked at doing this before, it was just
too expensive.

Ronnie

"Mike Spera" wrote in message
ink.net...
Still trying to find out if anyone has removed the old bowtie yokes
from
their shafts and replaced them with ram's horns. Lots of folks
changed
out
the yoke/shafts as units, but nobody will fess up that they actually
swapped out the yokes themselves.

Since Piper lists the yoke/shaft as one part number, there probably
is
no
approved method of separating them.

Looks like I will return the ram's horns with bent shafts I bought
from
the boneyard. If you cannot demate/remate them from/with the shafts,
they
are useless.

Thanks,
Mike