|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 20th 05, 07:13 AM
|
|||
|
|||
"John T" wrote in message ... Another test is to put it in a vise and beat the crap out of it with a hammer. If the tubes break before the welds, its a good weld. Right, that is the first part of step 2. Step one is to see if the welds are airtight, because aircraft welds should be, so corrosion (rust) does not eat away the tube, with no visible warning. -- Jim in NC 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AC 43.13, welding and a hip-check | Michael Horowitz | Owning | 2 | June 27th 04 07:09 PM |
| "I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 9th 04 11:35 PM |
| Small Aircraft Transportation System (SATS) first practical trial | Larry Dighera | Piloting | 0 | November 27th 03 03:11 PM |
| FA: WEATHER FLYING: A PRACTICAL BOOK ON FLYING | The Ink Company | Aviation Marketplace | 0 | November 5th 03 12:07 AM |
| TIG welding video? | Russell Duffy | Home Built | 3 | October 6th 03 05:55 AM |
Hybrid Mode
