![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() "Everett M. Greene" wrote: Now, if there are any EEs present, perhaps they can explain why aircraft radios tend to fail in this manner whereas nothing much of anything else in the electronic world fails in a manner to produce heat and smoke. Are avionics units designed so close to the components' limits to cause this failure mode? I can understand a transmitter going up in smoke (while transmitting), but a receiver? Receivers still contain amplifiers, power regulating transistors, resistors, diodes, etc. in their circuitry. Failures at the discrete component level can produce thermal events without increases in main power loads above circuit breaker limits. -- Dan C-172RG at BFM |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
GOLD RUSH PROGRAM | GOLD RUSH PROGRAM | Home Built | 1 | March 29th 05 09:33 PM |
Bill Cliton verses Rush Limbaugh | Transition Zone | Military Aviation | 14 | November 20th 03 05:13 PM |