|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 1st 05, 06:52 AM
|
|||
|
|||
Does this stuff "weld/melt" Polyesther the same way it does Polyvinyl Chloride?
Roger on the clear stuff. What about the question above? Thanks. Dean A. Scott, mfa --------------------------------------- School of Visual Art and Design southern adventist university --------------------------------------- http://www.southern.edu/~dascott 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dacron vs. polyfiber etc. | Adam Aulick | Home Built | 5 | August 3rd 05 04:25 PM |
| A Remote Compass- java source | [email protected] | General Aviation | 0 | July 3rd 04 06:39 PM |
| 4130 sheet source | Leon McAtee | Home Built | 7 | May 2nd 04 08:29 PM |
| Winscore source code now available | Guy Byars | Soaring | 0 | February 5th 04 10:43 AM |
| Source for copper crush gaskets??? | Jim | Owning | 0 | August 22nd 03 06:31 PM |
Hybrid Mode
