![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
![]()
George Patterson wrote:
No, it's not contrary. The "high to low" means a flight from an area of high pressure to low pressure, not high temperature to low temperature. When you decreased the temperature, you increased the pressure, which means you're going from low to high. Actually Geoerge, it works for temperature as well as pressure. Going to a colder than standard pressure causes your altimeter to read high as well. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
High Voltage | Jim Rosinski | Piloting | 7 | October 16th 04 10:48 PM |
Viagra and the Mile High Club | Cub Driver | Piloting | 17 | May 28th 04 09:22 PM |
FS2004: Ceilings/visibility too high | ajohnson | Simulators | 2 | March 15th 04 10:55 AM |
High DPI pictures of clouds | BoDEAN | Piloting | 2 | March 5th 04 12:07 PM |
AIM-54 Phoenix missile | Sujay Vijayendra | Military Aviation | 89 | November 3rd 03 09:47 PM |