![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
PS - PK's are hex-head sheet-metal screws fitted with a non-marring washer. That what we used before clecos came along.
Hoover, Do I have to 'smooth out' the hole after removing the PK's before putting in the rivets? I'd think that the various 'cuts' in the material due to the PK's might be a good starting point for a crack/rip to develope. The Monk |
Thread Tools | |
Display Modes | |
|
|