|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
January 4th 06, 01:13 AM
posted to rec.crafts.metalworking,rec.autos.tech,rec.aviation.homebuilt
|
|||
|
|||
see four-point sockets
Wright Tool used to make them, as well as a tool called a Bonney
wrench, in several sizes. The 8-pointers are common from Craftsman. Heads-up: Craftsman has an industrial catalog with sometimes better pricing and many tools not available at the retail outlets. They are very coy about giving the catalogs out but usually the local A&P school has their 800 number. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adding a lifting point. | [email protected] | Home Built | 1 | March 8th 05 03:05 PM |
| A Question For Real Airline Pilots | Blue | Simulators | 34 | September 6th 04 01:55 AM |
| flight training - 100nm night flight requirement | Jonathan | Piloting | 36 | May 11th 04 07:34 PM |
| How fast should an ADF point? | Ben Jackson | Instrument Flight Rules | 6 | November 21st 03 03:50 AM |
| Reaming needed on aft wing attach point. | Boelkowj | Home Built | 0 | November 7th 03 01:30 AM |
Hybrid Mode
