|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
January 17th 06, 02:04 AM
posted to rec.aviation.owning
|
|||
|
|||
Sticking Lycoming O-360 valve again?
George Patterson wrote:
: Well, there you are. Switch to 15W50 and your problems will go away. :-) Why didn't *I* think of that? ;-) -Cory -- ************************************************** *********************** * Cory Papenfuss * * Electrical Engineering candidate Ph.D. graduate student * * Virginia Polytechnic Institute and State University * ************************************************** *********************** 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Replacing fuel cut-off valve with non-a/c part??? | Michael Horowitz | Owning | 46 | January 15th 05 10:20 PM |
| Lycoming 0-360 factory overhaul core charges - Does Air Powertell the truth ? | Mike Spera | Owning | 6 | December 13th 04 01:13 AM |
| Harley engine special | Brett | Home Built | 106 | May 28th 04 03:10 AM |
| Q: Disecting a cut-off valve? | Michael Horowitz | Home Built | 0 | March 6th 04 01:47 PM |
| Lycoming Sued | jls | Home Built | 0 | February 13th 04 02:01 PM |
Hybrid Mode
