A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Owning
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

I took the garbage out tonight



 
 
Thread Tools Display Modes
  #1  
Old January 31st 06, 03:49 AM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

I've got a few gallons of used oil in the hangar in buckets since I
don't drink enough milk to put it all out for recycling. One of
these days I need to schlep it over to the big oil recycling tank
at a nearby airport.


If those are polypropylene milk jugs, you don't want to leave them
sitting very long. Polypropylene absorbs oil and will disintegrate if
left in contact with each other. Don't leave the jugs on the hangar
floor unless you want to clean a gooey mess. Is your hangar floor
epoxied?
  #2  
Old January 31st 06, 05:56 AM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

On 2006-01-31, john smith wrote:
I've got a few gallons of used oil in the hangar in buckets since I
don't drink enough milk to put it all out for recycling.


If those are polypropylene milk jugs, you don't want to leave them
sitting very long. Polypropylene absorbs oil and will disintegrate if
left in contact with each other.


Good to know. I actually have no milk jugs at all, so the oil is in
plastic buckets that originally held cat litter. It hadn't occured to
me to check for oil/plastic compatibility. The next vehicle I buy will
be suitable for hauling buckets of oil to somewhere I can dispose of it.

--
Ben Jackson

http://www.ben.com/
  #3  
Old January 31st 06, 06:07 PM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

Won't your FBO take it? I just take mine to the mechanic and dump it in
his sump. He does not mind. Our local Wal-Mart received old engine oil
at no charge. I would suspect the quick change oil places would do the same.

Ross
KSWI

Ben Jackson wrote:

On 2006-01-31, john smith wrote:

I've got a few gallons of used oil in the hangar in buckets since I
don't drink enough milk to put it all out for recycling.


If those are polypropylene milk jugs, you don't want to leave them
sitting very long. Polypropylene absorbs oil and will disintegrate if
left in contact with each other.



Good to know. I actually have no milk jugs at all, so the oil is in
plastic buckets that originally held cat litter. It hadn't occured to
me to check for oil/plastic compatibility. The next vehicle I buy will
be suitable for hauling buckets of oil to somewhere I can dispose of it.

  #4  
Old January 31st 06, 07:55 PM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

Ross Richardson wrote:
: Won't your FBO take it? I just take mine to the mechanic and dump it in
: his sump. He does not mind. Our local Wal-Mart received old engine oil
: at no charge. I would suspect the quick change oil places would do the same.

You should not take aircraft oil to an automotive waste oil dump from what
I've heard. They no longer expect to see the lead in the oil from 100LL.

-Cory

--

************************************************** ***********************
* Cory Papenfuss *
* Electrical Engineering candidate Ph.D. graduate student *
* Virginia Polytechnic Institute and State University *
************************************************** ***********************

  #5  
Old January 31st 06, 11:25 PM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

Try a farm implement dealer, a semi truck and trailer service center, a
dealer, or a quick lube. Remember, these guys get paid for their waste oil,
just like we do here at the farm. And the people that buy it from us really
don't care too much what it contains. I know ours contains diesel engine
oil, gasoline engine oil, (from both leaded and unleaded gas) hydraulic oil,
brake fluid, heavy oils, water, soap, detergents, washer fluid... just about
anything. My brother in law also drives a pickup route for one of these
companies, he goes from the quick lubes right to the airports in the area
and it all goes in the same tank. The company that he works for, filters
it, thins it with fuel oil, and sells it as a #4 furnace oil for industrial
furnaces.
Jim

"Ben Jackson" wrote in message
...
On 2006-01-31, john smith wrote:
I've got a few gallons of used oil in the hangar in buckets since I
don't drink enough milk to put it all out for recycling.


If those are polypropylene milk jugs, you don't want to leave them
sitting very long. Polypropylene absorbs oil and will disintegrate if
left in contact with each other.


Good to know. I actually have no milk jugs at all, so the oil is in
plastic buckets that originally held cat litter. It hadn't occured to
me to check for oil/plastic compatibility. The next vehicle I buy will
be suitable for hauling buckets of oil to somewhere I can dispose of it.

--
Ben Jackson

http://www.ben.com/



  #6  
Old January 31st 06, 11:03 PM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

"john smith" wrote in message
...
I've got a few gallons of used oil in the hangar in buckets since I
don't drink enough milk to put it all out for recycling. One of
these days I need to schlep it over to the big oil recycling tank
at a nearby airport.


If those are polypropylene milk jugs, you don't want to leave them
sitting very long. Polypropylene absorbs oil and will disintegrate if
left in contact with each other. Don't leave the jugs on the hangar
floor unless you want to clean a gooey mess. Is your hangar floor
epoxied?


You've had this happen, or you "heard about it"?

I've had old oil sit in milk jugs for a couple of years on the garage floor
(You never know when it might come in handy, right? :-) ). Never had a
problem.

--
Geoff
the sea hawk at wow way d0t com
remove spaces and make the obvious substitutions to reply by mail
Spell checking is left as an excercise for the reader.


  #7  
Old February 1st 06, 12:48 PM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

In article ,
"Capt. Geoffrey Thorpe" The Sea Hawk at wow way d0t com wrote:

"john smith" wrote in message
...
I've got a few gallons of used oil in the hangar in buckets since I
don't drink enough milk to put it all out for recycling. One of
these days I need to schlep it over to the big oil recycling tank
at a nearby airport.


If those are polypropylene milk jugs, you don't want to leave them
sitting very long. Polypropylene absorbs oil and will disintegrate if
left in contact with each other. Don't leave the jugs on the hangar
floor unless you want to clean a gooey mess. Is your hangar floor
epoxied?


You've had this happen, or you "heard about it"?


I have it happen... repeatedly!
After draining my oil, I inevitably leave it sit instead of taking it to
a drop off site right away.
I then have to scoop it into multiple polyethelynene trash bags and
scoure the congrete to get as much of the oil out of it as possible.
As we speak, I have two jugs from last summer still sitting here taking
up space.
  #8  
Old February 1st 06, 10:08 PM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

"john smith" wrote in message
...
In article ,

...
I have it happen... repeatedly!
After draining my oil, I inevitably leave it sit instead of taking it to
a drop off site right away.
I then have to scoop it into multiple polyethelynene trash bags and
scoure the congrete to get as much of the oil out of it as possible.
As we speak, I have two jugs from last summer still sitting here taking
up space.


OK. I guess all milk jugs are not created equal.

--
Geoff
the sea hawk at wow way d0t com
remove spaces and make the obvious substitutions to reply by mail
Spell checking is left as an excercise for the reader.


  #9  
Old February 1st 06, 05:44 PM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

I HAD one milk jug leak oil over my garage floor. The bottom fell out
when I picked it up. It had been in there about a month.

Ross
KSWI

Capt. Geoffrey Thorpe wrote:

"john smith" wrote in message
...

I've got a few gallons of used oil in the hangar in buckets since I
don't drink enough milk to put it all out for recycling. One of
these days I need to schlep it over to the big oil recycling tank
at a nearby airport.


If those are polypropylene milk jugs, you don't want to leave them
sitting very long. Polypropylene absorbs oil and will disintegrate if
left in contact with each other. Don't leave the jugs on the hangar
floor unless you want to clean a gooey mess. Is your hangar floor
epoxied?



You've had this happen, or you "heard about it"?

I've had old oil sit in milk jugs for a couple of years on the garage floor
(You never know when it might come in handy, right? :-) ). Never had a
problem.

--
Geoff
the sea hawk at wow way d0t com
remove spaces and make the obvious substitutions to reply by mail
Spell checking is left as an excercise for the reader.


  #10  
Old February 1st 06, 06:00 PM posted to rec.aviation.owning
external usenet poster
 
Posts: n/a
Default I took the garbage out tonight

("Ross Richardson" wrote)
I HAD one milk jug leak oil over my garage floor. The bottom fell out when
I picked it up. It had been in there about a month.



I had my first one leak last summer. They were sitting up off the floor on a
wooden step. One day there was a puddle of oil to clean up. Never had that
happen before. They had been there for many, many months.

For transporting to the oil dump/hazardous waste depot, I use a milk crate
lined with an open leaf bag. The jugs go in the bag.


Montblack

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
'Iraq War Conceived in Israel' author on Current Issues Television tonight... [email protected] Naval Aviation 0 November 10th 05 06:09 PM
Fun ATC/Top Gun MNF intro tonight Montblack Home Built 9 September 15th 05 11:43 PM
Fun ATC/Top Gun MNF intro tonight Montblack Owning 9 September 15th 05 11:43 PM
DC-9 runs into parked Airbus at MSP tonight Montblack Piloting 8 May 12th 05 11:06 PM
Tonight Show Toks Desalu Piloting 6 March 18th 04 03:05 AM


All times are GMT +1. The time now is 11:50 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.