![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Are you looking for the EASA approved ones or the traditional ones ?
"Phil Jeffery" wrote in message ... Does anyone know who still supplies these canopy holes? "Nyal Williams" wrote in message ... I have seen a glider that had a very small, round hole for the yaw string drilled in the canopy. The owner tied knots inside and out, tighly against the hole. That was probably 35 years ago and I don't remember what or who. I would not recommend it. |
#2
|
|||
|
|||
![]()
Milspec holes are the best, but expensive.
Hard to find now, due to extensive use in Iraq and Afghanistan - especially the 5.56 and 7.62 mm sizes. Kirk |
#3
|
|||
|
|||
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
60 Year Old Duct Tape | Jay Honeck | Piloting | 11 | January 15th 06 06:52 PM |
Gap Tape | TJ | Soaring | 0 | October 22nd 05 04:18 AM |
Teflon gap seal tape... | Marc Ramsey | Soaring | 10 | April 3rd 05 04:35 PM |
BrandNew-Vector Heavy Duty Plastic Construction Tape Dispenser 13 Peaces Left | [email protected] | Aviation Marketplace | 0 | April 29th 04 11:43 PM |
TURBULATOR TAPE ON VENTUS B | Ventus B | Soaring | 5 | February 18th 04 08:27 PM |