|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 23rd 06, 09:31 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Airframe finishing and tooling
nondem wrote:
The plane design I'm building uses 2x2x.125" 6061-T6 for the fuselage frame. I did notice that older versions of the same plans specified 6063-T351. I checked the specs on both and as I remember the 6061 is a stronger alloy. There is almost no aluminum sheet used in this design either...Just angles/square and round tubing for the most part. That sounds a lot like one of the late Graham Lee's UL designs. Close? Richard 
|
|
#2
May 24th 06, 01:03 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Airframe finishing and tooling
It's an Affordaplane...
|
|
#3
May 25th 06, 03:01 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Airframe finishing and tooling
"nondem" wrote in message ups.com... It's an Affordaplane... Short for VaporWare. See any fly at national flyins yet? -- Jim in NC
|
|
#4
May 25th 06, 05:14 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Airframe finishing and tooling
"Morgans" wrote:
"nondem" wrote in message ups.com... It's an Affordaplane... Short for VaporWare. When nondem first mentioned it, I did a Google search for it. There is a web site for it, even has pictures showing the ultralight in the air: http://affordaplane.com/
|
|
#5
May 25th 06, 01:03 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Airframe finishing and tooling
Yea, I just laid out the fuselage so I'll be at next years fly-in
|
|
#6
May 26th 06, 02:15 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Airframe finishing and tooling
"Jim Logajan" wrote in message . When nondem first mentioned it, I did a Google search for it. There is a web site for it, even has pictures showing the ultralight in the air: http://affordaplane.com/ Excuse Me! I thought this was the guy that popped up her a couple years ago, that was going to build "modular" planes. Kinda like folding up cardboard boxes. Yuck! -- Jim in NC
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
