|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
May 30th 06, 02:13 AM
posted to sci.electronics.design,rec.aviation.homebuilt
|
|||
|
|||
Thermal Divider
On Mon, 29 May 2006 17:48:07 -0700, the renowned "RST Engineering
\(jw\)" wrote: Now THERE'S a hell of a thought. Consider a "bar" three inches long with sensors at 1 and 2 inches. Betcha the temperature at the head (zero inches) is (temp 1) plus delta (temp 1 minus temp 2). Jim Are you assuming negligible heat loss from the bar itself? Best regards, Spehro Pefhany -- "it's the network..." "The Journey is the reward" Info for manufacturers: http://www.trexon.com Embedded software/hardware/analog Info for designers: http://www.speff.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Themi thermal locator | John Jones | Soaring | 5 | April 30th 04 04:16 AM |
| For Auction: Thermal Imaging Camera - One Day Left | sell2all | Rotorcraft | 0 | April 29th 04 08:29 PM |
| For Auction: Thermal Imaging Camera - One Day Left | sell2all | Home Built | 0 | April 29th 04 06:43 PM |
| Spin on thermal entry - how-to | Bill Daniels | Soaring | 0 | January 29th 04 05:43 PM |
| Thermal to Wave contact! | C.Fleming | Soaring | 1 | January 21st 04 01:54 PM |
Threaded Mode