IPC G1000

My real question is how would you do the partial panel approach part of an IPC in the G1000?

I'm not familiar with glass, but it seems that one should simulate
likely failure modes, and dangerous failure modes. An electrical
contact could go bad, and you'd lose the whole screen, for example.

Jose
--
The monkey turns the crank and thinks he's making the music.
for Email, make the obvious change in the address.

I'm not familiar with glass, but it seems that one should simulate
likely failure modes, and dangerous failure modes. An electrical
contact could go bad, and you'd lose the whole screen, for example.



That is sort of the whole point of my post, As it is currently set up
it's hard to simulate the kind of failures you would have in the real world.

Under stress in real IMC is not the palce to try and figure it out.

Paul