|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 16th 06, 10:00 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Marking sheetmetal
stol wrote:
Sharpies work great, come in several line widths and wipe off easy... Sharpies wipe off nicely with denatured alcohol and paper towel, which also cleans up wet epoxy, the manufacturing markings on sheet metal, Permatex, regular dirt... and isn't excessively toxic. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wire marking | Scott Vetter | Restoration | 1 | December 1st 04 03:23 AM |
Hybrid Mode
