|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 28th 06, 06:06 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Etching copper clad
"Juan Jimenez" wrote except I believe ferric chloride is also a hazmat, no? As you recently said, get with the program. Do some reading (in this thread, even) and report back. -- Jim in NC 
|
|
#2
December 28th 06, 06:29 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Etching copper clad
"Morgans" wrote in message ... "Juan Jimenez" wrote except I believe ferric chloride is also a hazmat, no? As you recently said, get with the program. Do some reading (in this thread, even) and report back. Oh, did you go into "monkey see, monkey do" mode now? chuckle Did ya miss the question mark? The difference between you and me is that I ask, rather than pretend I know something about which I don't know squat. The children's sandbox is -- thataway. -- Posted via a free Usenet account from http://www.teranews.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Copper in oil analysis ? | [email protected] | Owning | 8 | August 22nd 06 12:31 PM |
| Copper in oil analysis ? | [email protected] | Instrument Flight Rules | 8 | August 22nd 06 12:31 PM |
| high copper reading in oil analysis | [email protected] | Owning | 1 | March 26th 04 03:32 PM |
Hybrid Mode
