![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() karl gruber wrote: Some of you wanted to see the variable resistor in the line out to the temp probe. As most have found, the probe does not transmit the proper temp. Karl, I must have missed the earlier post. What is the issue with the OAT probe? |
#2
|
|||
|
|||
![]()
As supplied, it isn't calibrated.
Karl "mikem" wrote in message ps.com... karl gruber wrote: Some of you wanted to see the variable resistor in the line out to the temp probe. As most have found, the probe does not transmit the proper temp. Karl, I must have missed the earlier post. What is the issue with the OAT probe? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Garmin 530 WAAS? | Al G | Instrument Flight Rules | 53 | November 21st 06 11:30 PM |
CHT probe + resistor installed (final) | Jim Burns | Owning | 8 | September 10th 05 02:34 PM |
Pirep: Garmin GPSMAP 296 versus 295. (very long) | Jon Woellhaf | Piloting | 12 | September 4th 04 11:55 PM |
Amateur Review of the Garmin GPSMAP 296 GPS | Rhett | Products | 10 | April 29th 04 06:57 AM |
carb temp probe | Philippe Vessaire | Home Built | 1 | September 20th 03 08:21 AM |