|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 20th 07, 07:48 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
K Jetronic was A/C tool kit
Tri-Pacer wrote:
, Yep, got a Bosche K-tronic fuel injection unit on it.All mechanical,except elect. fuel pump.--automatic correction for density (altitude) Are you really using K-jet on an airplane? That's great! Won't G forces pull the air meter flap down (or up) ? Paul N1431A Not if you balance it with a larger counterweight--also added a couple of S.S.Springs & bored out the metering jets---Takes a wee bit more pressure to open , but it meters a 314 CID engine to the max. metering jets are hard as glass, but a dental burr is just the right size & cuts it easy. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking For a Tool | Curtis | Naval Aviation | 1 | October 20th 04 01:06 AM |
| Looking For a Tool | Curtis | Simulators | 0 | October 19th 04 08:58 PM |
| Looking For a Tool | Curtis | Soaring | 0 | October 19th 04 08:58 PM |
| xc tool. | Todd Neidinger | Piloting | 8 | July 22nd 04 04:29 PM |
| Tool query... | Tina Marie | Owning | 2 | July 15th 04 05:20 AM |
Hybrid Mode
