![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Hi Richard,
Usually pilots keep the nosewheel on the centerline, unless there is reason not to. Some of the posters here brought up good reasons not to stay on center. One thing that I don't think has been mentioned is that sometimes ATC makes the decision for you . An example would be when two aircraft are comeing toward eachother on the same taxiway. The dialog often goes something like this: "Cessna 123, Somewhere Ground Control, remain to the right side of taxiway A , watch for the Caravan approaching you" "Cessna 123, staying to the right." The wording can vary quite a bit, to include moving for vehicles, equipment, new taxi clearances, etc. I also realize, obviously, (and as mentioned by other posters) that even if ATC isn't involved or on the field airplanes tend to steer around one another and go off the taxi centerline ![]() Nice meeting you Richard. We aren't all bad mannered pilots here, please post and hopefully you will get the answers you need. Don't let the few turds around here keep you away- I don't post much, but there are some really great people in this group. Jamie |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Is Claus-Dieter Zink Lennie the Lurker? | [email protected] | Soaring | 2 | January 23rd 06 01:07 AM |
Will the real Lennie the Lurker step forward. | [email protected] | Soaring | 16 | March 21st 05 07:00 AM |
The flight of the Lurker | Lennie the Lurker | Home Built | 0 | August 14th 04 08:10 PM |
Longtime lurker now trying to get his helicopter license. | Aaron A. Anderson | Rotorcraft | 0 | June 20th 04 12:17 AM |
Question for Squirrel the Lurker | jls | Home Built | 0 | January 30th 04 02:41 PM |