|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 13th 07, 05:48 PM
posted to rec.aviation.soaring
|
|||
|
|||
Takeoff distances
Oh, I have no problem with a club collecting the data and making the
charts, but your post seems to state that those actions should be required before the FAA approves the tug installation. The FAA requirement if what I would object to. And no, it wouldn't require data for each serial number, but for each type of tug. Todd 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| measuring arm distances | Heino & Deanne Weisberg | Home Built | 1 | October 21st 05 05:49 PM |
| Stuck at work--need takeoff/landing distances for a 172 please | Yossarian | Piloting | 12 | July 14th 05 01:12 PM |
| Edge distances in steel | Ed Wischmeyer | Home Built | 3 | August 24th 04 10:53 PM |
| Are sectional paths correct across "long" distances? | vincent p. norris | General Aviation | 32 | March 25th 04 02:32 PM |
| Are sectional paths correct across "long" distances? | vincent p. norris | Piloting | 36 | March 25th 04 02:32 PM |
Hybrid Mode
