![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() "Bill Daniels" wrote The claim was made that this was significantly cheaper than T-hangers with the same ease of access to the airplanes. Cheaper because there was only one small door for 8 airplanes. It would also tend to lend itself to situations where there is a limited area for a taxiway, or access to the ramp. Less taxiway surface area to the entrance would be another reason to expect some cost savings. OK, I'm sold. Who is in for setting up a limited partnership for designing and building hangars like this all over the country? g The strange thing is, I'm about half serious. Humm. -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D design | island life | Rotorcraft | 4 | October 23rd 05 01:31 AM |
DR-107 One Design | [email protected] | Aerobatics | 0 | October 12th 05 09:45 PM |
3D design | island life | Rotorcraft | 0 | September 13th 05 02:36 PM |
old gyrocopter design? | E. Glaser | Rotorcraft | 1 | August 9th 05 03:52 AM |
Strop design | Edward Weaver | Soaring | 3 | July 20th 05 06:03 PM |