![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Thu, 7 Jun 2007 23:42:37 -0400, "Peter R."
wrote: Today I spotted two four inch and one six inch vertical cracks in the side window at the seat directly behind the pilot seat. The cracks are almost perfectly straight and originate at the top frame more or less in the middle of the window. The aircraft is a 1973 V35B and I would imagine that this window is that old. How does this happen? Old age? Cold to hot? Some other force that decided that one month since my last aviation maintenance expenditure was too long? my take on it is that the installation has probably always put extra stresses in the plastic in that area. as the plastic is exposed to uv radiation it gradually suffers depolymerisation, ie breaks in parts of the chains of molecules that make up the plastic. the plastic moves more with thermal changes than does the aluminium so with thermal changes such as you experience in climb to altitude there is some movement and stressing going on in the plastic. the plastic shrinks faster than the aircraft. over time the gradual reduction in strength and the stresses due to temperature change meet each other and you get a crack. how you treat the crack can add to it's severity. in plastic the tensile forces pulling the plastic apart (it will never crack in compression) are actually magnified by the shape of the crack at the very tip of the crack. once a crack starts the stress buildup at the tip of the crack will tend to make it propagate across the sheet of plastic. the method of halting the crack is to drill a small hole just beyond the crack. the shape of the tip of the crack is then changed from a sharp stress riser to a more broad distribution of stresses. if the plastic in the area has sufficient strength to handle the reduced stresses in the area then that is the end of the propagation of the crack. an eighth inch drill is typically used. in your guess above, deterioration due to age (uv radiation effects) and Hot to cold leading to tensile forces in the plastic locally exceeding its strength. dont feel special. we all need to replace plastic windows occasionally. btw how your guy mounts the new window is important to having that window last beyound the warranty period. Stealth Pilot Australia. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Saturn V S-IC (first) stage are placed side by side prior to commencement of the mating of the two stages 6416485.jpg | [email protected] | Aviation Photos | 0 | April 12th 07 01:28 AM |
For Mitchell Holman, if you want them... - F-15 & F-16 on pedestals WPAFB side by side.JPG (1/1) | Blue Oval/Dan Edwards | Aviation Photos | 4 | January 19th 07 01:19 AM |
Side window install | Jim Burns | Owning | 3 | August 11th 05 03:59 PM |
Is That a Resistor Wired Between the Hot Side and the Switch Side of the Solenoid? | jls | Owning | 3 | April 11th 04 04:55 PM |
FS: Piper Side Window (New) | JimC | Aviation Marketplace | 0 | August 10th 03 12:19 PM |