|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 21st 07, 03:10 PM
posted to rec.aviation.soaring
|
|||
|
|||
Woodstock spars
On Jun 21, 4:41 am, MartyH wrote:
Does anyone know where I might find enough Douglas Fir suitable for use for spars for the Woodstock 12 meter wing? I need pieces in the 12ft range. Does anyone know where I can have these spars made if I dont want to do them myself? This project doesnt go very far without spars! P.S. you may want to avoid telling them it's for an airplane. This tends to send up everyone's liability antenna and they might refuse to supply material if they know it's going into a glider. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Woodstock Plans | [email protected] | Soaring | 4 | August 10th 06 11:11 PM |
| Query on the Woodstock | Stealth Pilot | Soaring | 3 | July 25th 06 08:02 PM |
| Woodstock Plans F/S | [email protected] | Soaring | 0 | May 16th 05 10:06 PM |
| Titanium spars and composites on F-22 | Scott Ferrin | Military Aviation | 1 | December 4th 03 03:21 PM |
| S-H Spars: Anyone check for voids laterally? | Mark Grubb | Soaring | 1 | September 20th 03 04:27 AM |
Hybrid Mode
