![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() "David Lesher" wrote Some lines actually used spheres between, but they bring their own problems... A little further OT,... I've watched a lot of heavy #6 (needs to be heated to pump) unloaded at the offshore platform. When the tanker is empty, we pig the pipe and backfill with #2. The methods seem crude to the observer, but the results are exact enough even for the accountants. |
#2
|
|||
|
|||
![]() "Mike Isaksen" wrote A little further OT,... I've watched a lot of heavy #6 (needs to be heated to pump) unloaded at the offshore platform. When the tanker is empty, we pig the pipe and backfill with #2. The methods seem crude to the observer, but the results are exact enough even for the accountants. Care to explain a little more, for the unfamiliar among us? Pig the pipe? Backfill with #2? What is that? Why is it possible to be considered as crude, and why is it accurate? -- Jim in NC |
#3
|
|||
|
|||
![]()
"Morgans" writes:
"Mike Isaksen" wrote A little further OT,... I've watched a lot of heavy #6 (needs to be heated to pump) unloaded at the offshore platform. When the tanker is empty, we pig the pipe and backfill with #2. The methods seem crude to the observer, but the results are exact enough even for the accountants. Care to explain a little more, for the unfamiliar among us? Pig the pipe? Backfill with #2? What is that? #6 Bunker is one step up from road tar. It's what's left over when you take all the good stuph out at the refinery. It's CHEAP, so BIG ships burned it. But it is virually solid when cold. So first it must be heated to pump. Remember WWII movies about "bringing another boiler on line"? They used handheld Kerosene torches to bootstrap the process; then waste steam from the boiler.. #2 is Fuel Oil; slight heavier than #1 aka Kerosene. (Diesel is #2 with added goodies.) If they left #6 in the line, they'd be SOL as it cooled. So they use thinner stuff to displace it. A pig is a scraper. You run it down a line to scrape gunk off the walls. It's pushed by the line flow. There are several types: A poly pig is a GIANT Tylonol capsule. A conventional pig is a disk [picture an old LP..] the ID of the line, with a gasket around the edge. The center hole has a shaft trailing back with wire brushes articulated from it; they're spring-loaded outward to scrape the wall. You pig the line while pushing Kero or Fuel Oil; the dirt settles into the destination tank bottom... -- A host is a host from coast to & no one will talk to a host that's close........[v].(301) 56-LINUX Unless the host (that isn't close).........................pob 1433 is busy, hung or dead....................................20915-1433 |
#4
|
|||
|
|||
![]() He may cut early. middle or late; it depends on the two products. The schedulers try to make adjacent 'tenders' friendly. Interesting post. Thanks Dave Paul N1431A KPLU |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gasohol | Blueskies | Piloting | 240 | July 6th 07 12:42 AM |
Gasohol | Blueskies | Owning | 233 | June 30th 07 03:50 AM |
How scary is gasohol? | Charles Talleyrand | Owning | 27 | March 1st 04 11:39 AM |