|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 18th 03, 03:38 AM
|
|||
|
|||
Sand the area where you want it coated.
Brush on a film of epoxy, Like the West Systems epoxy. It seals the fibers. Larry Fitzgerald 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Auto Fuel STC | Jeff | Home Built | 62 | September 24th 03 02:41 AM |
| Fuel pressure Problems | smf | Home Built | 3 | September 7th 03 08:25 PM |
| Christen Fuel Pump troubleshooting | ShawnD2112 | Aerobatics | 4 | August 17th 03 12:08 PM |
| Fiberglass Vacuum Bagging Technique...Resin Infusion | Steve | Home Built | 5 | August 8th 03 06:10 PM |
| Question ~ Does fuel injection add weight? | Barnyard BOb -- | Home Built | 0 | July 6th 03 09:47 PM |
Hybrid Mode
