|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
July 14th 07, 05:20 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Rudd Aeroplane Co. Oakland, CA
RST Engineering wrote:
Especially if it accepts a 7/116" wrench, which I ain't seen one around lately. Jim It's used for really fine adjustments? Dan, U.S. Air Force, retired 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flying clubs in Oakland or Concord? | [email protected] | Piloting | 3 | September 22nd 05 11:08 PM |
| Request tips on flying from Arkansas to Oakland, CA in December | Bert G. | Piloting | 7 | December 7th 04 06:02 AM |
| NAS OAKLAND? | Jdf4cheval | Naval Aviation | 8 | October 30th 04 06:38 PM |
| An aeroplane that can stand still in air | Chandresh Prakash | Military Aviation | 47 | January 11th 04 11:31 AM |
| Origin of "aeroplane" | Geoff May | Military Aviation | 18 | July 4th 03 11:42 AM |
Hybrid Mode
